I purchased a kit to make a table runner that features 4 basket blocks. I've cut all the pieces and started piecing them together. All was well until I went to attach the base or vase to the flowers. When I stitched those together, my points ended up in the seam line.
So, I increased the size of the two triangles that surrounded the point piece and was able to achieve 1/4 inch of fabric surrounding the point piece. Beautiful.
Now, as I go to add the base, I find that the diagonal length is a full inch short of what is needed to complete the "square."
The instructions state that the finished block is 8-inches. Mine is shaping up to be 9-inches. I've double and triple checked my piece cutting measurements and my 1/4-inch seams.
I'm new to quilting... is this a common dilemma with patterns? Am I okay to keep adjusting? I realize it will change the entire completed project, which is why I'm writing.
I am such a visual person that I would need to see a picture of your block. I don't remember needing to add seam allowances as I go when I'm following a pattern. THat usually happens when I try it wing it. Hope to see a pic soon, maybe you misread something in the pattern??
I follow what the pattern says to cut as that normally has your 1/4 inch seam allowance in it already. But do not mistake that all patterns are correct. I always buy a 1/2 of a yard more than needed in case of mistakes and a need to re-cut a piece or two. If I don't need it I can use it in a table runner later tee hee. So If your points are all matching, use a squaring ruler and trim the block properly to square. Your blocks may be a bit larger then what is in the pattern, but when it is all put together it will look just as beautiful.
Julienne, Mid MO
So here's the picture of the basket block. The two light colored triangles at the bottom had to be adjusted from a 2-7/8" square cut diagonally to a 3-1/4" square so that the point in the middle would not be sewn into the seam allowance.
Because of that, the large triangle that completes the square had to be increased in size to fit.
I am now thinking (since this was a kit and I don't have extra fabric) that I should go back to the original light/dark blocks, rip them apart and trim 1/8-inch off each.
It really is not bad at all as far as misshapen is concerned. If you have enough fabric you can go with the bigger square. I would just square up the sides. When you sew the blocks together you will still have your 1/4 inch seam and it will still turn out just as beautiful.
If you already have every piece cut don't go back and do that.
The problem now is that if I keep increasing everything to make it fit then I don't have enough fabric. Actually, I think I can just go back and re-stitch the triangles to make the light/dark block smaller and then remove the original stitching. Then I can square everything and hopefully be back on track.
Looks great to me. But I'm still struggling with the eiths measurements myself so I don't have the answer.
Nana what did you mean delete?
Quilting My Rainbow
Ok, found out what went wrong. I took the block down to the half-square-triangle units that started out as 3-1/4 squares. I trimmed them all to EXACTLY 2-3/4 inch and was getting ready to head to the machine when I happened to glance down and see instructions that told me to trim them to 2-1/2 inch squares!
I saw the "trim..." before, I just didn't realize it was trimming a whole 1/4-inch off two different sides.
So, rookie mistake. Thanks to everyone for your input :)